Users who attempt to connect to the wireless modem will be prompted for the password.
If you setup leave them as is, anyone on the network can make changes to the router by entering the default username and password.
Some Belkin routers setup use admin as the username, while others may use.
If you didn't set a password, leave the field router blank.Power on the Belkin wireless modem if it isn't already turned on, and then router locate the Reset button on the back of the device.His articles have appeared in dozens of technical password publications, including MSN UK, cnet, BBC Who Do You Think You Are, LifeHacker UK and TechRadar.Tip, the names of fields may differ, depending on the modem you are configuring.If you don't know the password, you must reset the modem to access this interface.You may have to wait for at least 1 minute for the router to restart.Step 3, wait approximately one minute until the router restarts, and then navigate to " using any Web browser.Admin (with an uppercase, a ).The easiest way to get the default username and password back is to reset the router to its factory default settings through a hard reset.To access the routers GUI, all you need to do is open your browser and type http 192.168.2.1 in the address bar.Default credentials are set on routers at the factory. You will be prompted to enter a username and a password.
You can also Go to Start, then access Run, and type (http then hit enter.




You can use a pin, paper clip, or a toothpick to press and hold the autocad reset button for about autocad 10 seconds.Resetting a router restores the credentials and deletes custom settings that were set up such as a wireless network name and password, DNS servers, and port forwarding settings.Like most home broadband routers, the administration screens of crack Belkin routers are password-protected.Join to access discussion forums and premium features of the site.To do so, open a web browser then game type (http in sepage the address bar, then in the login page, use the default username and password then click the login button.When you access the router's homepage using its.The router automatically reboots when it resets.Chances are, though, that your Belkin router doesn't have a username by default or it uses admin.Step 5, change the Timeout value if you prefer to configure the router to log you out automatically after a period of time.Its easy to change the routers default password.Step 2, enter your password into the Password field and click the "Submit" button to log in to the interface. Click "System Settings" in the Utilities section of the left navigation water pane.
Resources, about the Author, nick Peers has been writing technology-related articles since serial 2003.